Click to email me

Sitemapper
RAMBo Firmware

A number of M2 hardware upgrades including the Z motor, dual extruder, and LCD controller may require an update to the RAMBo firmware.

Firmware upgrades can be completed without any problems following the the MakerGear firmware upgrade instructions using the appropriate firmware for your RAMBo revision and the update.

The RAMBo firmware for a Revision D M2 with a black Z motor and dual extruder does not support the LCD controller.  MakerGear technical support have provided an earlier firmware revision (M2-Marlin-RRDSC_LCD-ZMin-12-11-2015.zip) that apparently supports a revision D M2 with a black Z motor, dual extruder and an LCD controller.  The firmware update was painless, with the new version confirmed in the M2 start-up text using Pronterface.

If you have any questions, comments or suggestions please email me.  I will respond.  Otherwise click here to navigate to installing an LCD controller...

[Turtles are Here] [Site Map] [750Z Housing] [Construction] [A20 Housing] [Drawings] [Galapagos] [Data Logger] [Making PCBs] [PCB Drill] [CD Welder] [Current Monitor] [Proportional Controller] [Lock In Amplifier] [NAD C 520] [Kenwood Tape Deck] [Tape to Computer] [Reflow Oven] [Designed to Fail] [M2 3D Printer] [Assembly] [Prints] [Objects de-Art] [Lab Gear] [Surface Finish] [Blocked Nozzle] [M2 Upgrades] [Flexible Prints] [Print Problems] [Extruder Failure] [X, Y & Z Calibration] [Coil Winders] [Changing a Light Bulb] [Squash Racquet Repair] [Dive Photos] [Sand Casting] [Oxy-MAPP] [Lathe Maintenance] [Thermal Adhesive] [M73 Compass Repair] [Calcium Block for Turtles] [Infinite R Network] [ST7820 LCD] [Links] [Contact Me]