Click to email me

Metal Extruder Mount

Before beginning this upgrade you will need to print out the shroud box Revision 2 for cable marshalling and housing.  This revision is lighter and more robust that the original rectangular shroud box.  Sorting out the cables takes some time and patience but otherwise the upgrade was quite straight forward following the MakerGear guidance.

When mounting the shroud box be sure to press it forward against the metal motor housing when engaging the 4 mm mounting bolts otherwise it will not sit securely.  Note that you may need some additional cable ties, and be sure to remove any tape on the wiring harness before adjusting individual cable lengths in the loom.



Figure 2.  New Metal Extruder Motor Mount


If you have any questions, comments or suggestions please email me.  I will respond.  Otherwise click here to navigate to replacing the Z motor and Z end stop...


[Turtles are Here] [Site Map] [750Z Housing] [Construction] [A20 Housing] [Drawings] [Galapagos] [Data Logger] [Making PCBs] [PCB Drill] [CD Welder] [Current Monitor] [Proportional Controller] [Lock In Amplifier] [NAD C 520] [Kenwood Tape Deck] [Tape to Computer] [Reflow Oven] [Designed to Fail] [M2 3D Printer] [Assembly] [Prints] [Objects de-Art] [Lab Gear] [Surface Finish] [Blocked Nozzle] [M2 Upgrades] [Flexing Prints] [Print Problems] [Extruder Failure] [X, Y & Z Calibration] [NinjaFlex] [Gears] [Coil Winders] [Changing a Light Bulb] [Squash Racquet Repair] [Dive Photos] [Sand Casting] [Oxy-MAPP] [Lathe Maintenance] [Thermal Adhesive] [M73 Compass Repair] [Calcium Block for Turtles] [Infinite R Network] [ST7820 LCD] [Northern Lights] [Links] [Contact Me]